1. Inspect and Repair Leaky Faucets

• 🛠 Check indoor and outdoor faucets.
• ✅ Replace washers or cartridges if you spot leaks.
• 💧 Leaky faucets waste water and increase utility bills.

2. Service Your Water Heater

• 🔁 Flush the tank to remove sediment buildup.
• 🌡 Set the temperature to 120°F to prevent scalding and save energy.
• ⚠️ Check for rust, corrosion, or strange noises.

3. Check Your Sprinkler System

• 🌱 Run a full cycle and inspect heads for cracks or clogs.
• 🧭 Adjust sprinkler heads to avoid wasting water on sidewalks or driveways.
• ⏱️ Use a timer to prevent overwatering.

4. Inspect Sewer Lines

• 🌳 Tree roots grow aggressively in summer and can block lines.
• 🚽 Watch for slow drains or toilet bubbling—signs of a backup.
• 📞 Call a plumber for a camera inspection if needed.

5. Clean Gutters and Downspouts

• 🧹 Remove leaves and debris that may have accumulated in spring.
• 💦 Ensure water flows away from your home’s foundation.

6. Check Washing Machine Hoses

• 🔍 Inspect for bulging, cracking, or leaking.
• 🔁 Replace with braided stainless steel hoses for durability.
• 🕒 Avoid running the washer during peak heat to reduce water strain.

7. Test Outdoor Spigots and Hoses

• 🚿 Turn on outdoor faucets and look for leaks.
• 💥 A dripping spigot may indicate a freeze-damaged pipe from winter.
• 🔧 Replace worn washers and tighten fittings.

8. Install Water Leak Detectors

• 📱 Use smart leak sensors near sinks, heaters, and washers.
• 🔔 Receive alerts on your phone in case of water leaks while you’re away.

9. Know Where Your Main Shut-Off Valve Is

• 🚪 In case of a sudden leak or pipe burst, knowing this can prevent major water
  damage.
• 🧭 Usually found near the water meter or where the main line enters your house.

BONUS TIP: Go Green

• 💡 Consider low-flow showerheads and faucets to conserve water.
• 🌞 If you’re planning upgrades, think about a solar water heater.